R&D Test Cars Needed.

Blog readers, greetings from the Tein USA Research and Development Section.

In the past, a majority of the blog posts done by R&D have been on vehicles which we had finished our testing on. We simply wanted to report on future products that you, the consumers, could look forward to.

As of late, however, we in R&D have run into a problem. We no longer have test cars to do testing on.

You see, with the continual release of new vehicles and models, there is no way for us to constantly look to just a few sources to provide us with these vehicles to do testing on.

We are completely reliant upon the consumers and enthusiasts, like yourself, to provide us with their personal vehicles to do the aforementioned testing on.

About the Testing itself:

Depending on the testing and the products being tested, the time frame that we require your vehicle for is usually 3-5 days.

Thinking of being without a vehicle for a bit of time may be a huge deterrent for many.

However, look on the bright side.

Free Suspension! Depending on the application, you may walk out with our lowering springs or you may walk out with  a set of our coilovers.

The installation will be professionally done by the R&D Engineers.


After the installation is finished we will perform a Basic Front-End Alignment and you’ll also be the first person to own the product.

If that sparks your interest and if you have the time to allow us with your vehicle, then check out this link and find out if your car is one of those that we are looking for. If you happen not to find your car on the list, no need to fret, check back every once in a while and we just may be in need of your car sometime down the line.